Ei Electronics Ei171RF Uživatelský manuál

This product may be purchased from Connevans Limitedsecure online store at www.DeafEquipment.co.ukDeafEquipment.co.ukOffering you choiceHelping you ch

9Template for Mounting ScrewsDrill Holes Here12V180mA(max)Aux112V20mA(max)Aux2Conversion JackRemoveprotectionplug beforeconnectingaccessoriesFigure 5B

10 INDICATOR SUMMARYModeStandby -MAINS / STANDBYGreen LightALARMRed LightFAULTAmber LightSTROBELightRADIOLINKBlue LightAux1Aux2Amber LightMains onon

11MainsIndicatorGreen(mainsdisconnected =amber flash/4 seconds)RadioLINKSignallingBlueControl Panel IndicatorsAlarmRedFaultIndicatorAmberStrobeTESTALA

12© Ei Electronics 2009P/N B16566 Rev0Aico Ltd. Mile End Business Park,Maesbury Rd, Oswestry, Shropshire SY10 8NN, U.K.Tel: 0870 758 4000 www.aico.co.

Strobe Light ModuleDeaf & Hearing ImpairedRadioLINK Alarm System For use with RadioLINK Smoke/Heat/Fire Alarms (Smoke / Heat / Fire Alarmsupplied

The Ei171RF is for use with the following Ei RadioLINK Smoke/Fire/Heat Alarms and Accessories.Mains Multisensor/Smoke/Heat/Fire Alarms: Ei2110, Ei160R

Plug the battery into the socket at the rear of the battery compartment as shown in Figure 2 (whileholding the small latch on the battery plug, open).

If connecting to a mains Junction BoxIt is preferable to permanently wire the unit into a mains junction box. In this case remove theplug and wire as

Strobe Module until the blue light turns on, then release. The blue light should stop flashing and an‘exit House Code Mode’ radio signal will be sent

4. TESTING AND MAINTAINING YOUR SYSTEM4.1 AFTER INSTALLATION4.1.1 Check that all RadioLINK Alarms and Accessories are powered correctly.4.1.2 Check th

The battery also needs to be replaced if it is over 5 years old (see “replace battery by” date on sidepanel). To remove the battery reverse the instru

Ei408 - RadioLINK Switched Input Module: This allows panels or other devices with Volt-free relayoutputs to trigger the RadioLINK system, including th